Introduction
We’ve built a Replacement lamp for Rapid Thermal Processing (RTP) systems, and honestly? It’s a straight swap. Drop it in, and you’re back up and running. The whole point was simple: deliver rock-solid, high-intensity heat for those exact thermal cycles your line needs—performance that holds its own against the big names, right there on the factory floor.
What Makes It Work: Power, Voltage, and Fit
Here’s the thing about RTP: it needs a very specific kind of power. So we built this lamp to run at 400V, packing the punch needed for serious power density. That higher voltage also means less current running through your wiring. Less strain on your power supply, less energy lost as heat. And the fit? We machined the length and diameter to match the chamber’s optical path perfectly. So the heat hits the wafer evenly, every single time.
The Inside Story: Halogen, Quartz, and a Simple Hookup
Inside, you’ve got a halogen cycle heating element tucked inside a high-purity quartz envelope. This combo keeps the light output steady and stops the element from darkening over time—which means a longer life for the lamp. The quartz itself is tough enough to handle rapid temperature swings without cracking. And the connector? It’s a standard R7s type. That means installation is quick, clean, and repeatable. Just wire it up and go. Minimal downtime. No drama.
Life on the Wafer Floor: Built for the Real World
On the wafer floor, downtime isn’t just inconvenient—it’s lost wafers. So this lamp had to be reliable when the pressure’s on. It delivers the fast ramp-up rates you need for annealing and doping, no sweat. But packing that much power into a compact tube does generate serious heat. So your system’s cooling has to be up to the task. If the chamber cooling can’t keep pace, the lamp won’t perform at its best. We’re not asking you to take our word for it. We’re putting our numbers up against the competition, because the only proof that matters is what happens during an on-site performance test.